fabriframe

FABRIFRAME OVERVIEW

FabriFrame is a revolutionary fabric tension system which is so versatile the creative possibilities are huge. It can be mounted onto walls, doors or ceilings with a fabric graphic applied to the face, or be a free standing unit or partition wall, with a single or even a double facing fabric graphic.

The system is created from a lightweight aluminium frame which can be fitted on-site by our installation team or, depending on size, sent as a flat pack unit for you to assemble yourself.

The frames comes in a variety of profile depths ranging from 20mm to 100mm, with the ability to be cut and finished to create almost any shape you can imagine.

 

FABRIFRAME FEATURES

Custom sizes and profile depths:
The frames systems are made custom with many profile depths to accommodate your lighting option. They can be freestanding, cover entire walls and ceilings or several smaller sections.

Printable:
We print the fabric using a dye sublimation technique to produce vibrant, crisp images which create maximum impact.

Replaceable:
FabriFrame graphics can be replaced and updated if required which allows the panels to be used for illuminated marketing messages, brand awareness or sell advertising space.

Installation:
Our qualified team carry out a site survey to evaluate the area and then install the system at a time convenient to you.

 

FABRIC SPECIFICATION

Our preferred fabric for the FabriFrame system is a 215 gsm (+3%), 100% polyester substrate which is available in widths of 3200mm. It has been finished with INKTeX+BS® for direct print with diverse inks with flame retardant treatment. This fabric has been classified as DIN 4102-B1 and EN13501.

The FabriFrame light-block fabric is suitable for when external lighting may effect the graphic from behind. This is a 100% polyester with a black rear coating. At approximately 235 gsm (+3%) it is available at 3000mm width. It has been finished with INKTeX+BS® for direct print with diverse inks with flame retardant treatment. This fabric has been classified as DIN 4102-B1 and EN13501.

 

STRETCH RATES

When fabric is printed and the colour is sealed there is usually a shrinkage of approximately 1-2%. Therefore it is important that if you are providing artwork for a FabriFrame system, you allow at least 25mm bleed with crop marks offset to 25mm.

 

FRAME SPECIFICATION

The sturdy, lightweight aluminium frame is made from 6063 T6 aluminium.

 

APPLICATION USES

The FabriFrame aluminium frame can be fabricated as one large frame, several connecting frames, a free-standing unit or a full wall/ceiling covering.

 

GRAPHIC SYSTEM

Silicon beading is stitched to the edge of the fabric graphic, which sits securely into the aluminium frame.